Table of Contents
Advertisement
Obtaining Reports
Figure 8‐3: Downlink ‐ Performance Monitoring report ‐ Valid data
The on‐screen report may be scrolled vertically and horizontally. The meaning of the column
headings is shown in the following table:
Table 8‐2: Performance Monitoring Fields
Abbreviation
Column Heading
Meaning
Integrity
Valid data flag
Date & Time
Time stamp
Unavailable
UAS
Seconds
ES
Errored seconds
Severe Errored
SES
Seconds
Background
BBE
Block Error
Received
Rx MBytes
Mbytes
Transmitted
Tx MBytes
Mbytes
Above Traffic
Threshold set in
Thresh
Figure 8‐2
Active Seconds
RADWIN 2000+ Series User Manual
Description
Green checkmark for current and valid; Red cross for
invalidated data (See example below). Note that the
Performance Monitoring data is not valid if not all the
values were stored (e.g., due to clock changes within
the interval or power up reset)
Data are recorded every 15 minutes; the last 30 days
of recordings are maintained. Roll‐over is at midnight.
Seconds in which the interface was out of service.
The number of seconds in which there was at least
one error block.
The number of seconds in which the service quality
was low as determined by the BBER threshold.
The number of errored blocks in an interval.
The number of Megabytes received at the specified
port within the interval
The number of Megabytes transmitted at the
specified port within the interval.
Seconds count when actual traffic exceeded the
threshold
The number of seconds that the configured Ethernet
service is active
Release 4.2.40
8‐8
Advertisement
Table of Contents
