Figure 6-7 Link Air Interface - Radwin 2000+ SERIES User Manual

Air Interface
Figure 6‐7: Link Air Interface parameters ‐ DBS enabled, ACS on by default
Figure 6‐5 to Figure 6‐7 contain a subset of the Activation Air Interface settings. You may only
change the Operating channel with ACS disabled.
These parameters are automatically inherited by the RT‐B(HSU) when you click OK.
Throughput Mode
The Advanced button enables you to choose a throughput mode:
Throughput Mode determines how the Adaptive Modulation mechanism works. Maximum
Throughput (default) should be chosen if throughput is more important than higher delay.
Conversely, Reduced Latency minimizes delay at the expense of lower throughput.
Link ID
You may change this to any convenient string. After you click OK, the RT‐B(HSU) will be
immediately updated over the air without interruption to service.
RADWIN 2000+ Series User Manual Release 4.2.40 6‐18