Throughput Checking
The content of the Diagnostics report is an aggregate of all the more specific reports
discussed below. It is primarily intended for use by RADWIN Customer Service.
The Spectrum Analysis output is available directly from the Spectrum
View utility as a CSV file (see Spectrum View). The format in the
Diagnostics report is intended for use by RADWIN Customer Service.
The Spectrum Analysis section of the Diagnostics report is based on the
last available spectrum analysis (if any). If you are submitting a support
request involving interference issues, or if you are specifically asked by
Customer Service to submit a Diagnostics report containing a recent
spectrum analysis, you should carry out the analysis in accordance with
the Spectrum View instructions prior to using the Get Diagnostics facility.
8.2 Throughput Checking
In this mode, RADWIN 2000+ Series estimates Ethernet throughput by filling frames over the
air to maximum for 30 seconds. This mode should not influence service.
To use Throughput Checking:
1. Chose Estimated Throughput from the Tools tab:
RADWIN 2000+ Series User Manual
Release 4.2.40
8‐3