Configuration Of Vlan Tagging For Ethernet Service - Radwin 2000+ SERIES User Manual

Configuration of VLAN Tagging for Ethernet Service
• The outer tag has to be the Provider's tag (so the frame is not filtered)
• The internal tag has to be management VLAN ID
To avoid mix‐ups, best practice is to:
• Separate the management and data ports
• Define only a data port with Provider function
15.5.2 Configuration of VLAN Tagging for Ethernet Service

To set up an RT‐B(HSU) for VLAN tagging:
1. Open Link Configuration | Ethernet and then click the VLAN Configuration button.
In Disabled mode, Ethernet frames pass transparently over the radio links.
2. For Provider tagging, click the Provider Radio button:
In Provider mode, Ethernet frames are tagged with the provider's VLAN ID before
they enter into the provider's network/backbone.
3. Enter a Provider VLAN ID and Priority. The VLAN ID must be in the range 2 to 4094.
The VLAN Priority must be in the range 0 to 7. You may also change the TPID from
the default as shown.
4. Click OK to accept.
5. For user VLAN tagging, click the Tag Radio button:
RADWIN 2000+ Series User Manual Release 4.2.40 15‐5