Telnet Access to Either ODU
Table 6‐2: ODU Telnet ‐ Display Commands (Continued)
Command
display PM <interface:AIR,LAN1>
<interval:current,day,month>
display bands
display ldpc_mode
Table 6‐3: ODU Telnet ‐ Set Immediate Commands
Command
set ip <ipaddr> <subnetMask>
<gateway>
set trap <index:1‐10> <ipaddr>
<port:0‐65535>
set readpw <oldpasswd> <passwd>
set writepw <oldpasswd> <passwd>
set trappw <oldpasswd> <passwd>
set buzzer <mode>
set tpc<power:Value between
minimal Tx power, and maximal Tx
power>
set name <new name>
set location <new location>
set contact <new contact>
set ethernet <port:LAN1>
<mode:AUTO,10H,10F,100H,100F,D
ISABLE>
reboot
help
RADWIN 2000+ Series User Manual
Explanation
Shows the performance monitor tables for each
interface according to user defined monitoring
intervals
Displays available bands
On or off; default off
Explanation
Set the radio unit IP address, subnet mask and
gateway. The user must reset the radio unit after the
command completion
Set a specific trap from the traps table (e.g. set trap 3
192.168.101 162)
Set the read access password (Read Community)
Set the read‐write access password (Read‐Write
Community)
Set the trap Community string
mode: 0 = off, 1 = auto, 2 = on
Set the radio unit Tx Power. If a wrong value is
entered, both min and max values shall be displayed
in the error reply
Set the name of the link
Set the name of the location
Set the name of the site manager
Set the mode and speed of the Ethernet port
Resets the radio unit. The user is warned that the
command will reset the radio unit. A new Telnet
session to the radio unit may be opened after the
reset is complete.
Displays the available commands
Release 4.2.40
6‐29