Deactivate Rt-A(Hbs); Deregister Rt-B(Hsu); Suspend A Deregistered Rt-B(Hsu); Reset The Odu - Radwin 2000+ SERIES User Manual

Deactivate RT‐A(HBS)
Auto ‐ Buzzer responds according to signal strength. This is the setting used for antenna
alignment. For details see Antenna Alignment on page 4‐39
Advanced Auto ‐ Buzzer on while link down, remains on for an extra two minutes.
Refresh
The Refresh button restores the current window to its previous state abandoning any changes
you made, provided that you did not click Apply or OK.
7.5 Deactivate RT‐A(HBS)
Deactivating the RT‐A(HBS) halts traffic over the link and drops it back to the default
transmission mode prior to configuration with one exception: The RT‐B(HSU) remains
"registered" but inaccessible over the air. You can reactivate the RT‐A(HBS) without need to
re‐register the RT‐B(HSU). All of the RT‐B(HSU) configuration settings are preserved.
7.6 Deregister RT‐B(HSU)
Deregistering the RT‐B(HSU) stops link traffics but leaves it accessible over the air from the RT‐
A(HBS). All of the RT‐B(HSU) tool bar functions are available.
7.7 Suspend a Deregistered RT‐B(HSU)
You may break the link (cause a full sync loss) to the deregistered RT‐B(HSU) for a fixed
amount of time.
7.8 Reset the ODU
The reset functions are equivalent to powering the ODU down and then powering it up again.
RADWIN 2000+ Series User Manual Release 4.2.40 7‐28