Radwin 2000+ SERIES User Manual page 188

Configuring GHSS with an Internal GPS Unit
4. Before you can change the Protocol from Ethernet to GPS, you must first choose the
Operational State as Hub Sync Client ‐ Continue Tx or Hub Sync Client ‐ Disable Tx,
according to your preference.
• HSS Client‐Continue Transmission (HSC‐CT): If the unit loses synchronization with
the HSS Master, the link remains active. However, without synchronization pulses,
it is possible that this unit will cause interference.
• HSS Client‐Disable Transmission (HSC‐DT): If the unit loses synchronization with
the HSS Master, the link is dropped until the synchronization pulses resume. This
setting prevents the unit from causing interference.
RADWIN 2000+ Series User Manual Release 4.2.40 12‐11