Tensioning A Used Tread Belt - Technogym RUN PERSONAL Service Maintenance Manual

8.2. TENSIONING A USED TREAD BELT

Figure 8.2-1
Figure 8.2-2
This procedure is normally carried out after replacing the driving roller or rear roller,
or in cases where a used tread-belt cannot be reassembled with the procedure of
paragraph: 8.1. "Tensioning a new tread belt", because the belt is not elastic.
Page 8.2
RUN PERSONAL: Service & maintenance manual - rev. 3.1
a. Before slackening a used tread belt that needs
to later be re-tensioned, place a tape measure
along the center of the tread belt and use a
pen to make two reference marks spaced
exactly 1m meter apart.
b. After reassembling the used tread belt,
alternately lock down the 2 rear screws (a)
until the two marks made previously on the
tread belt are once again spaced 1 meter
apart.
CAUTION:
procedure, check the centering of the
tread belt as instructed in paragraph:
8.3. "Centering and adjusting the belt".
After completing this