RUN PERSONAL: Service & maintenance manual - rev. 3.1
7.13. DISASSEMBLING THE FRONT WHEELS
This operation can be carried out by placing the machine at a 3 or 4% incline before
turning it over on one side; or, alternatively, by resting the machine on one side and
removing the elevation motor pin and clip, as described in paragraph: 7.11.4.
"Disassembling the elevation motor (D)", up until step (2), so as to release the elevation
carriage from the frame.
Figure 7.13-1
Figure 7.13-2
Before to proceed, place some cartoons
or protective stuff to avoid damage the
lateral casings and upright of the
machine.
Carefully turn the machine over one
side, taking care that the elevation
carriage is not touching on the floor
then it's free to move.
1. Pull the incline frame slightly toward
yourself.
2. Remove the caps (a) using a flat screwdriver
as a lever.
3. Back off the screw (b), using an 8mm hex
wrench and holding the nut (c) underneath in
place with a 17mm socket wrench.
Continued on following page...
Page 7.43