Technogym RUN PERSONAL Service Maintenance Manual page 108

Figure 7.10-12
Figure 7.10-13
Page 7.24
RUN PERSONAL: Service & maintenance manual - rev. 3.1
15. Back off the 4 screws (o).
16. Remove the upright (p) by pulling it outward
and then lifting it upward.
17. Back off the 15 screws (q) using a 5mm hex
wrench to remove and/or replace: the cables
(r), the side guards (s) and (t), the handlebar
(u) and the frame (v).
If the cables passing through the side
uprights need to be replaced, note that
they are distributed as follows:
 Right upright:
Power supply cable for CU319 and
CU317 panels.
 Left upright:
Audio/Video and AUDIO OUT signal
cables.
To reassemble the guard and the side uprights,
carry out the above steps in reverse order taking
special care to correctly match up the guards as
before.