Disassembling The Side Uprights - Technogym RUN PERSONAL Service Maintenance Manual

7.10.2. D
ISASSEMBLING THE SIDE UPRIGHTS
Figure 7.10-6
Figure 7.10-7
Figure 7.10-8
Page 7.22
RUN PERSONAL: Service & maintenance manual - rev. 3.1
:
At this point, carry out the operations described
in paragraph: 7.4. "Disassembling the display"
and 7.9. "Disassembling the center handlebar
and joystick".
On the upper part:
6. Back off the screw (f) using a 2.5mm hex
wrench, passing through the hole of the bottle
holder, as shown in the figure.
7. Remove the guard (g) by snapping it off.
8. Back off the 2 nuts (h) using a 13mm wrench
on either side.
9. Remove the bar (i).
On the lower part:
10. Back off the screw (j) using a medium
Phillips screwdriver.
Continued on following page...