7.14.1.
P
OSITION
Figure 7.14-4
ATTENTION: Take particular attention when move the Autotransformer, because it
is easily broken, also a little impact can damage it.
3. Pull out the autotransformer cable from the frame, trough the holes highlighted in the figure, in
direction of the yellow arrows.
4. Remove the autotransformer assembly.
To reassemble the Autotransformer, carry out the above steps in reverse order.
Page 7.46
A
Figure 7.14-5
RUN PERSONAL: Service & maintenance manual - rev. 3.1
1. Back off the 7 screws (a) using a 4mm
hexagonal wrench.
Open lightly the autotransformer guard (b),
2.
with caution.
Continued on following page ...