RUN PERSONAL: Service & maintenance manual - rev. 3.1
7.11.6. D
ISASSEMBLING THE BELT TENSIONER
Figure 7.11-21
(F)
Carry out the procedure described in paragraph:
7.11.5. "Disassembling the Tread belt motor
(E)".
1. Back off the screw (a) using a 17mm wrench.
2. Remove the lever of the tension system (F).
To remove the roller:
3. Back off the nut (b) and the bolt on the
opposite side using two 17mm wrenches.
4. Remove the wheel (c).
To reassemble the belt tension system, follow the
above steps in reverse order
Page 7.35