Disassembling The Autotransformer - Technogym RUN PERSONAL Service Maintenance Manual

RUN PERSONAL: Service & maintenance manual - rev. 3.1
7.14. DISASSEMBLING THE AUTOTRANSFORMER (VER. 110V)
Figure 7.14-1
TIPOLOGY 1
Figure 7.14-2
TIPOLOGY 2
Figure 7.14-3
For the operations that follow: turn off the
machine and unplug the mains lead from the
wall outlet.
Carry out the procedure described in paragraph:
7.10.1. "Disassembling the low kit guard" and
7.11.1. "Disassembling the ALE Drive".
1. Remove the ferrite (a) from the Driver
connecting cable.
2. Disconnect the two connectors (b) and (c).
Before to proceed, place some cartoons
or protective stuff to avoid damage the
lateral casings and upright of the
machine.
Turn the equipment on the right side.
If the Autotransformer is in the A
POSITION, as shown in the figure at
the side, carry out as indicated at the
procedure: 7.14.1. "Position A".
If on
Autotransformer is in B POSITION, it
is strongly suggested to turn the
machine on left side and carry out the
procedure: 7.14.2. "Position B".
Continued on following page ...
the contrary,
Page 7.45
the