Technogym RUN PERSONAL Service Maintenance Manual page 114

Figure 7.11-10
Figure 7.11-11
Figure 7.11-12
Page 7.30
RUN PERSONAL: Service & maintenance manual - rev. 3.1
4. Disconnect the LAN cable and the antenna
cable from the connectors on the guard.
5. Now it is possible to remove the lower guard.
6. Back off the 2 bolts using a 10mm wrench
and remove the bracket and the elevation
microswitch (f).
CAUTION: After reassembly, check
the position of the microswitch as
described in paragraph: 8.5. "Travel
limit microswitch position".
To reassemble the elevation microswitch, carry
out the above steps in reverse order.
Disassembling the
board:
7. Back off the 2 screws (a) using a medium
Phillips screwdriver.
8. Remove the connector board (b).
To reassemble the connector board, carry out
the above steps in reverse order.
Audio/Video connector