Hand Sensor - Technogym RUN PERSONAL Service Maintenance Manual

RUN PERSONAL: Service & maintenance manual - rev. 3.1
6.15.2. H S
AND ENSOR
HUMAN BODY "CONTINUITY": it's well known that for somebody it's very
difficult, nearly impossible, to measure their HR using the hand sensors. This due to a
lot of possible causes which could fake the "quality" of the contact between the human
skin and the HS plates, as: hands only just washed or particularly dry, acidity of the
skin and/or a particular body fat mass index. For these people it's suggested to wear
the chest belt transmitter.
HS CORRECT USE: Grasp both the upper and lower plate avoiding to clench them
too hardly. Avoid to wash the hands using soaps that can dry the skin too much.
Receiv er Board
def ectiv e.
Replace.
THE TELEMETRIC HR
SIGNAL IS INCORRECT

(Hand Sensor)

Check the Display SW
v ersione and the grounding of
the Receiv er Board.
NO
NO
Set the priority on the
Hand Sensor.
Problem solv ed?
NO
NO
Check the state of
wear of Hand Sensor cable.
Problem solv ed?
1
YES
OK
2
YES
OK
3
YES
OK
Page 6.31