Disassembling The Emergency Stop - Technogym RUN PERSONAL Service Maintenance Manual

7.6. DISASSEMBLING THE EMERGENCY STOP

Figure 7.6-1
Figure 7.6-2
Page 7.16
RUN PERSONAL: Service & maintenance manual - rev. 3.1
Carry out the procedure described in paragraph:
7.1. "Disassembling the touch screen", up to
step (4) of the Figure 7.1-3.
1. Disconnect the emergency cable indicated in
the figure.
2. Back off the 2 screws (a) using a 4mm hex
wrench.
3. Back off the 2 screws (b) using a small
Phillips screwdriver.
4. Remove the two magnetic sensors.
To reassemble the emergency stop, carry out the
above steps in reverse order.