8.4. ALIGNING THE TREAD – BELT MOTOR DRIVE-BELT
Figure 8.4-1
Page 8.4
RUN PERSONAL: Service & maintenance manual - rev. 3.1
Carry out the operations up to step (2) of
paragraph: 7.10. "Disassembling the motor
guard and side uprights".
1. Remove the dust guard.
2. Release the spring (a) of the belt tensioning
mechanism.
3. Align the motor flywheel (b), using the 4
screws (c), with the pulley (d).
4. Align the motor drive-belt by shifting it
within the races of the pulley (d).
5. After completing the alignment, re-engage
the spring (a) of the tensioning mechanism
and lock down the screws (c) of the motor
support.