RUN PERSONAL: Service & maintenance manual - rev. 3.1
Figure 7.12-7
Figure 7.12-8
Figure 7.12-9
To remove the driven roller, driving roller,
motor drive-belt, tread belt and deck:
8. Slacken the belt tension by backing off the
screws (h) on each side, which act on the rear
machine roller, using an 8 mm hex wrench.
Carry out this operation by alternately
backing off the left and right screw to
avoid overloading the roller bearings.
9. Lift up the driven roller (i) and remove it.
10. Release the spring of the belt tension system
as
described
"Disassembling the Tread belt motor (E)", at
the point (1).
11. Pull out the belt (j) from the driving roller (k)
as shown in the figure.
Continued on following page...
in
paragraph:
7.11.5.
Page 7.39