ABB RED615 Technical Manual page 665

1YHT530004D05 D
615 series
Technical Manual
Parameter Values (Range) Unit
High trigger 0.00...60.00
level
Low trigger 0.00...2.00
level
Storage mode 0=Waveform
1=Trend /
cycle
1) Recordable values are available only in trend mode. In waveform mode, samples for this signal type
are constant zeroes. However, these signal types can be used to trigger the recorder on limit
violations of the corresponding analog channel.
Table 577: Non-group binary channel settings for disturbance recorder
Parameter Values (Range) Unit
Operation 1=on
5=off
Level trigger 1=Positive or
mode Rising
2=Negative or
Falling
3=Both
4=Level
trigger off
Storage mode 0=Waveform
1=Trend /
cycle
Channel id 0 to 64
text characters,
alphanumeric
Table 578: Control data for disturbance recorder
Parameter Values (Range) Unit
Trig recording 0=Cancel
1=Trig
Clear 0=Cancel
recordings 1=Clear
Measurement functions
Step
pu 0.01
pu 0.01
1
Step
1
1
1
Step
Section 8
Default Description
10.00 High trigger
level for the
analog
channel
0.00 Low trigger
level for the
analog
channel
0 Storage mode
for the analog
channel
Default Description
5=off Binary
channel is
enabled or
disabled
1=Rising Level trigger
mode for the
binary
channel
0 Storage mode
for the binary
channel
DR binary Identification
channel X text for the
analog
channel used
in the
COMTRADE
format
Default Description
Trigger the
disturbance
recording
Clear all
recordings
currently in
memory
659