Jam At Tray/Remove Tray 2 (Duplex Jam 2) - Xerox 3450B - Phaser B/W Laser Printer Service Manual

Jam At Tray/Remove Tray 2 (Duplex Jam 2)

Paper Jam between the Duplex Feed Rollers and the Registration Rollers.
Troubleshooting References
Applicable Parts
Duplex Exit Sensor Actuator
Duplex Assembly
Feed Roller Assembly
Print Engine Controller Board
Procedure
Step Action and Questions
Is the Duplex Sensor Actuator damaged or
1
binding?
Use the embedded diagnostics to check the
2
Duplex Sensor. Is the sensor operational?
Inspect the Duplex Assembly. Is any paper
3
wrapped around the Duplex rollers?
Is the Duplex Roller operational (rotates freely
4
without binding)?
Does the Feed Roller Assembly operate
5
properly without binding?
General Troubleshooting
s3450-168
Wiring and Plug/Jack Map References
Yes
Repair or
replace the
actuator and/or
sensor.
Go to Step 3.
Remove
obstruction and
clean rollers.
Go to Step 5.
Replace Print
Engine
Controller
Board.
No
Go to Step 2.
Replace Duplex
Sensor.
Go to Step 4.
Replace Duplex
Assembly.
Replace the
Feed Roller
Assembly.
4-13