Analog Output Am/Ami Terminals; Fm Adjustment; Am/Ami Selection - Omron 3G3RX User Manual

FM Adjustment
•Adjust the Inverter output gain according to the meter connected to the FM terminal.
Parameter No. Function name
C105 FM gain setting
Related functions

Analog Output AM/AMI Terminals

You can monitor the output frequency and current using the AM and AMI terminals on the control
circuit terminal block.
The AM terminal provides 0- to 10-V analog output.
The AMI terminal provides 4- to 20-mA analog output.
AM/AMI Selection
•Select a signal to output from the following table.
Parameter
Function name
No.
AM selection
C028/C029
AMI selection
*1. This output is enabled only when "SLV", "0-Hz SLV", or "V2" is selected. (Refer to "Control Method (V/f
Characteristics)" (page 4-21).)
*2. Below are the specifications of the output torque (signed).
AM output (V)
*3. In any other method the real output frequency of the inverter including compensations (different than d001
value) is displayed.
50 to 200: Set a gain for the FM monitor.
00: Output frequency (0 to Max. frequency (Hz)
01: Output current (0% to 200%)
*1
02: Output torque (0% to 200%)
04: Output voltage (0% to 100%)
05: Power (0% to 200%)
06: Thermal load rate (0% to 100%)
07: LAD frequency (0 to Max. frequency [Hz])
09: Motor temperature (0C to 200C) (0C output at 0C or
/
lower)
10: Fin temperature
(0C to 200C) (0C output at 0C or lower)
11: Output torque (signed)
(AM output only. 0% to 200%
13: Drive programming output (YA1) (AM selection only)
14: Drive programming output (YA2) (AMI selection only)
19: Option board 1 (OP1) (AM selection only)
20: Option board 2 (OP2) (AM selection only)
AM gain setting (C106) = 100%
10
5
0
100 200
Data
C027, b081
Data
*3
)
*1 *2
)
AM gain setting (C106) = 200%
AM bias setting (C109) = 50%
Torque (%)
4-2 Function Mode
Default setting Unit
100 %
Default
Unit
setting

00
4-110
4