Forced Operator Function - Omron 3G3RX User Manual

4-2 Function Mode

Forced Operator Function

•This function forcibly enables operation via the Digital Operator by turning on/off the multi-function
terminal if the frequency reference/RUN command sources are not set to the Digital Operator.
Data
31
Available input terminals
Related codes
4
•If the Forced Operator function is selected in the multi-function input selection, the Inverter is
operated with the signal from the frequency reference source and RUN command source selected
in A001 and A002, when the input signal is OFF. When the signal is ON, the Inverter is forced to
operate with the frequency reference or RUN command from the Digital Operator.
•If you switch on/off this function during operation, the RUN command is reset to stop the Inverter
output. Before resuming operation, turn off the RUN command from each command source to
avoid possible danger and then input it again.
4-91
Symbol Function name
OPE Forced operator
Status
Prioritizes the command from the Digital Operator (A020,
ON
A220 set values) over the A001 and A002 settings.
OFF Operates according to the A001 and A002 settings.
C001 to C008
A001, A002
Description