Omron 3G3RX User Manual page 425

Parameter
Function name
No.
Multi-function output
terminal 11 contact
C031 selection
[Output [11] actv.
state]
Multi-function output
terminal 12 contact
C032 selection
[Output [12] actv.
state]
Multi-function output
terminal 13 contact
C033 selection
[Output [13] actv.
state]
Multi-function output
terminal 14 contact
C034 selection
[Output [14] actv.
state]
Multi-function output
terminal 15 contact
C035 selection
[Output [15] actv.
state]
Relay output (AL2,
AL1) contact
C036 selection
[Alarm RLY active
state]
Light load signal
output mode
C038
[LOC out mode
select]
Light load detection
C039 level
[LOC out level]
Overload warning
signal output mode
C040
[Overload warn
mode]
Overload warning
C041 level
[Overload warn level]
* 2nd/3rd control is displayed when "SET(08)/SET3(17)" is allocated to one of multi-function inputs from C001
to C008.
Monitor or data range
00: NO
01: NC
00: NO contact at AL2; NC contact at AL1
01: NC contact at AL2; NO contact at AL1
00: ACC/DEC/CST (Enabled during
acceleration/deceleration/constant
speed)
01: Const (Enabled only during constant
speed)
0.0 to 2.00 × Rated current (0.4 to 55 kW)
0.0 to 1.80 × Rated current (75 to 132 kW)
00: ACC/DEC/CST (Enabled during
acceleration/deceleration/constant
speed)
01: Const (Enabled only during constant
speed)
0.0: Does not operate.
0.1 × Rated current to 2.00 × Rated current
(0.4 to 55 kW)
0.1 × Rated current to 1.80 × Rated current
(75 to 132 kW)
Appendix-1 Parameter List
Changes
Default
during Unit
setting
operation
00

No
01

01 No
Rated
No A
current

01 No
Rated
No A
current
App-30
Page
4-96
4-106
4-49