Installation When Using Internet Printing Protocol (Ipp); Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox DocuCentre-IV 2060 Administrator's Manual

Installation When Using Internet Printing Protocol (IPP)

Step 1 Preparations

Step 2 Configuration on the Machine

1
2
Downloaded From ManualsPrinter.com Manuals
This section describes how to install the machine using Internet Printing Protocol (IPP).
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 261
Step 2 Configuration on the Machine ...................................................................................... 261
Step 3 Configuration on the Computer .................................................................................... 262
CentreWare Internet Services Setting Items ............................................................................ 262
Note • If the size of print data sent via IPP is larger than the value set in the proxy server, the
machine cannot receive the data. In this case, set a larger value in the proxy server or
change your browser setting not to use the proxy server.
The following items are required to set up the machine to use Internet Printing Protocol
(IPP).
TCP/IP network environment
The Driver CD Kit (provided with the machine or optional)
The following describes the configuration procedures to use Internet Printing Protocol
(IPP) on the machine. Enable the IPP port, and then configure TCP/IP settings.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit. For
information on how to configure the setting using the Driver CD Kit, refer to the manual
contained in the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.262).
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
Enable the IPP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [IPP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.

Installation When Using Internet Printing Protocol (IPP)

7
261