Fuji Xerox DocuCentre-IV 2060 Administrator's Manual page 52

2 Paper and Other Media
5
6
2
7
8
9
10
50
Downloaded From ManualsPrinter.com Manuals
Unscrew the screw of the front guide and
remove the guide from the tray.
Insert the small protrusions at the bottom of
the guide into the holes corresponding to the paper size ( ). Insert the protrusion on
the tray into a hole corresponding to the paper size on the top of the guide, and tighten
up the screw ( ).
Pull up the lever of the end guide ( ). Move
the lever along the slot, and set it at the
position corresponding to the paper size
( ). And then press the lever down ( ).
Important • Adjust the end guide correctly to the size
of the paper. If the end guide is not
adjusted correctly, the machine cannot
feed the paper properly, resulting in paper
jams.
Note • The slot to the left of 8.5" is not used.
Open the end guide ( ), and load and align
the edge of the paper against the right edge
of the tray with the side to be copied or
printed on facing down ( ).
Important • Do not load paper above the maximum fill
line ("MAX" in the right figure). It may
cause paper jams or machine
malfunction.
Close the end guide securely.
Push the tray in gently until it stops.