Fuji Xerox DocuCentre-IV 2060 Administrator's Manual page 598

16 Appendix
16
596
Downloaded From ManualsPrinter.com Manuals
When the port status is set to [Enabled], it may automatically switch to [Disabled] if
the machine has insufficient memory. In this case, either set an unused port to
[Disabled] or adjust the assigned memory size.
Adjust the receiving buffer size for SMB in [Receiving Buffer - SMB] according to
usage. If the receiving buffer size is smaller than the transmitted data, the machine
may not be able to receive the data.
Configuration on the Computer
IP addresses are managed for the entire system. Configure the settings only after
consulting your network administrator.
When setting the network such as IP addresses with a host used under the Network
Information Service (NIS), consult your NIS administrator.
Turning Off the Machine
Check the following points when turning off the machine:
When [Receiving Buffer - SMB] is set to [Spool to Memory]
All print data spooled within the machine memory, including the data which is being
printed, is erased. The print data does not remain when the machine is turned on
again.
However, if the machine was turned off immediately after a computer instructed a
print job, the job may remain on the computer. In this case, when the machine is
turned on, the data stored on the computer is printed before any jobs instructed
subsequently.
When [Receiving Buffer - SMB] is set to [Spool to Hard Disk]
All print data spooled in the machine hard disk, including the data which is being
printed, is saved. In this case, when the machine is turned on, the data stored on the
machine hard disk is printed before any jobs instructed subsequently.
When [Receiving Buffer - SMB] is set to [No Spooling]
All print data spooled in the machine receiving buffer, including the data which is
being printed, is erased. The print data does not remain when the machine is turned
on again.
However, if the machine was turned off immediately after a computer instructed a
print job, the job may remain on the computer. In this case, when the machine is
turned on, the data stored on the computer is printed before any jobs instructed
subsequently.
While Printing
When [Receiving Buffer - SMB] is set to either [Spool to Hard Disk] or [Spool to
Memory]
If the transmitted print data size exceeds the available capacity of either the hard disk
or memory, the print data is not received.
Note • When the print data exceeds the receivable size, some computers may immediately re-
transmit the print data. In this case, the computer appears to be not operating. Remedy this
problem by canceling the print data transmission from the computer.
When [Receiving Buffer - SMB] is set to [No Spooling]
When the machine receives a print request from a computer, the machine cannot
accept print requests from any other computers.