Table of Contents
Advertisement
5 Tools
Check EP Connection
Initialize Hard Disk
Delete All Data
Software Options
5
Power on Self Test
Check Smart Card Details
Finisher Adjustment
Software Upgrade
124
Downloaded From ManualsPrinter.com Manuals
This feature is used to check whether the communications between the machine and our
Customer Support Center function normally when the EP system via the Internet is used.
Note
• The EP system may not be available in some regions. For more information, contact our
Customer Support Center.
For information on the EP system, refer to "EP System" (P.613).
Initializes the hard disk.
Data deleted by initialization includes supplementary fonts, ESC/P, and HP-GL/2 forms.
Note
• The secure print documents and logs are not erased.
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. All data stored on the machine will be deleted.
Before executing this operation, make sure that the operation is absolutely necessary.
Note
• It takes several minutes to several hours to delete all data. (The time taken depends on the
machine configuration or the hard disk capacity.)
This feature is for service representative use. For more information, contact our Customer
Support Center.
Set whether or not to perform self test when the machine is turned on and started up. If any
abnormal condition such as intentional program modification is found during the program
diagnosis, the machine stops starting up and records the information in the audit log.
Note
• The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact our Customer Support Center.
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
You can register the authentication information using CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
This feature is displayed only when the Finisher-B1 (optional), the Booklet Maker Unit for
Finisher-B1 (optional), or the Hole Punch Unit (optional) is installed.
Hole Punch Tool
Specify either 2/4 Hole Punch or 2/3 Hole Punch (US Specification).
Adjust Punch Position/Booklet Fold Position
Set the punch position and booklet fold position for paper smaller than B4 or larger than or
equal to B4.
When EP system via the Internet is used, this feature is used to upgrade the software for EP
system when the version upgrade is required.
Important • After the downloading is finished, the machine automatically restarts and upgrades the
software. After the machine restarts again and the [Services Home] screen is displayed, the
software upgrade is completed.
Advertisement
Table of Contents
