Fuji Xerox DocuCentre-IV 2060 Administrator's Manual page 137

Encryption Key for Confidential Data
1
2
3
4
Service Rep. Restricted Operation
Downloaded From ManualsPrinter.com Manuals
• Make sure that the hard disk and encryption settings match. Otherwise, an error will occur.
For information on error messages and their remedies, refer to "Other Errors" (P.488).
• The following procedure is recommended for changing the encryption settings while a large
amount of data (100 jobs or more) is stored in a folder, and [Number of Overwrites] is set to
[1 Overwrite] or [3 Overwrites] under [Overwrite Hard Disk].
1. Select [Tools] > [Setup] > [Create Folder] to display the [Create Folder] screen.
2. Select the folder, and then select [Delete Folder].
3. Select [Close].
4. Press the <Machine Status> button, and confirm that [Standby] in [Overwrite Hard Disk] is
displayed.
5. Enter the System Administration mode, and change the data encryption settings.
For information on how to enter the System Administration mode, refer to "System Settings
Procedure" (P.98).
• Our service representative cannot restore the encryption key.
• When our service representative replaces the electrical circuit board, the encryption key is
initialized. Do not lose the encrypted information.
Allows you to set an encryption key to encrypt confidential information such as the passcode
of the system administrator and a folder. Encrypting confidential information prevents a
network hacking and an unauthorized access to the information.
Enter an encryption key of 4 to 12 single-byte characters using alphanumeric characters.
Important • If you change the existing encryption key, you may not restore confidential information from
a backup.
Note • The factory default encryption key is "x-admin".
Select [Encryption Key for Confidential Data], and then [Change Settings].
Select [New Encryption Key], and enter an encryption key, and then select [Save].
Select [Re-enter Encryption Key], enter the same encryption key, and then select [Save].
Select [Save] to display a confirmation screen. Select [Yes] on the screen to save the
setting.
Allows you to select whether or not to restrict the operation by our service representative to
protect the security settings from being altered by someone impersonating our service
representative.
Off
The operation by our service representative is not restricted.
On
Our service representative cannot change the following settings:
"Delete All Data" (P.124)
"Print Universal Unique ID" (P.128)
"Data Encryption" (P.134)
"Encryption Key for Confidential Data" (P.135)
"Service Rep. Restricted Operation" (P.135)
"SSL/TLS Settings" (P.164)
"S/MIME Settings" (P.165)
"IPSec Settings" (P.166)
"System Administrator Settings" (P.229)
"Maximum Login Attempts" (P.234)
Common Service Settings
135
5