Delete All Data; Software Options; Finisher Adjustment - Fuji Xerox ApeosPort-V 7080 Administrator's Manual

Initialize Hard Disk
Initializes the hard disk.
Data deleted by initialization includes supplementary fonts, ESC/P, and HP-GL/2 forms.
Note

Delete All Data

This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. All data stored on the machine will be deleted.
Before executing the operation, make sure that the operation is absolutely necessary.
Note

Software Options

This feature is for service representative use. For more information, contact our Customer
Support Center.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up.
If any abnormal condition such as intentional program modification is found during the
program diagnosis, the machine stops starting up and records the information in the audit
log.
Note
Check Smart Card Details
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
Note
Important • To display the online help for CentreWare Internet Services, users need to have the environment to

Finisher Adjustment

This feature is available when the C3 Finisher/C3 Finisher with Booklet Maker is installed
with a punch unit.
Hole Punch Tool
Specify either [2/4 Hole Punch] or [2/3 Hole Punch (US Specification)].
Adjust Fold Position
You can adjust the fold position for each paper type and can set up to 10 adjustment type.
Also, you can assign the type to each tray.
Fold Position Type Setup
Adjust the position for Single Fold, Booklet, C Fold, Z Fold, and Z Fold Half Sheet.
For more information on setting procedures, refer to "Fold Position Adjustment" (P.626).
Trays 1 to 4, and 6
Assign an adjustment type to each tray.
• The secure print documents and logs are not erased.
• It takes several minutes to several hours to delete all data. (The time taken depends on the machine
configuration or the hard disk capacity.)
• The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact our Customer Support Center.
• You can register the authentication information using CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
connect to the Internet. The communication fee shall be borne by you.
Common Service Settings
147
5