O3: Copy Function - YASKAWA T1000V Technical Manual

5.10 o: Operator Related Settings
o2-06: Operation Selection when Digital LCD Operator is Disconnected
■
Determines if the drive will stop when an external LCD operator is removed in LOCAL mode or with b1-02 set to 0.
Note: An LCD operator is available as an option. This setting is not applicable to the standard LED operator that comes with the drive.
No.
o2-06 Operation Selection when Digital Operator is Disconnected
Setting 0: Continue Operation
The operation is continued.
Setting 1: Trigger a Fault
The operation is stopped and an "oPr" fault is triggered. The motor coasts to stop.
o2-07: Motor Direction at Power Up when Using Operator
■
Determines the direction the motor will rotate after the drive is powered up when the Run command is set to be given
from the digital operator.
Note: This parameter is effective only when the Run command is set to be given from the digital operator (b1-02 or b1-16 = 0).
No.
o2-07 Motor Direction at Power Up when Using Operator
Setting 0: Forward
Setting 1: Reverse

◆ o3: Copy Function

Use o3 parameters to Read, Copy, and Verify the parameter settings to and from the drive.
o3-01 Copy Function Selection
■
This parameter controls the copying of parameters to and from the LED operator (option). The copy function will change
certain parameter default settings depending on the regional specification of the drive.
No.
o3-01
0: COPY SELECT (no function)
1: INV --> OP READ
All parameters are copied from the drive to the LED operator.
2: OP --> INV WRITE
All parameters are copied from the LED operator to the drive.
3: OP<-->INV VERIFY
Parameter settings in the drive are compared to those in the LED operator.
Note: When using the copy function, the drive model number (o2-04) and the software number (U1-14) must match or an error will
occur.
o3-02 Copy Allowed Selection
■
Enables and disables the digital operator copy functions.
No.
o3-02
0: Disabled
No digital operator copy functions are allowed
1: Enabled
Copying allowed
216
Name
Name
Name
Copy Function Selection
Name
Copy Allowed Selection
YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual
Setting Range
0 or 1
Setting Range
0 or 1
Setting Range
0 or 1
Setting Range
0, 1
Default
0
Default
0
Default
0
Default
0