YASKAWA T1000V Technical Manual page 293

Figure 7.8
Terminal Board Replacement
■
1.
Replace the removable terminal block on the drive according to
Figure 7.9
2.
Ensure the terminal block is firmly fastened to the connector.
Figure 7.10
3.
Put the lower cover and the terminal cover back in place.
4.
Once the drive has been replaced, check the drive unit selection setting in o2-04. For more information, refer to
o2-04: Drive Model Selection on page
5.
An oPE04 error may occur when replacing the drive or the removable terminal block. If the data on saved to the
terminal block is compatible, then set A1-03 = 5550. This will write the parameter settings stored in the terminal
block to the new drive.
Reset the appropriate Maintenance Monitors using parameters o4-01 through o4-13.
YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual
Figure 7.8 Removable Terminal Board disconnected from the drive
Figure 7.9 Terminal Board Replacement
Figure 7.10 Terminal Board Installed
215.
Figure 7.9
Place the terminal board below the
guide tracks in the plastic case of the
drive. Then push it gently down and
slide it toward the keypad until the
locking pin clicks into place.
Connector
7.5 Drive Replacement
293
7