Ricoh B064 SERIES Service Manual page 1336

ERROR CODES
Code Meaning
0-32 The other terminal sent a
DCS, which contained
functions that the receiving
machine cannot handle.
0-33 The data reception (not
ECM) is not completed
within 10 minutes.
0-52 Polarity changed during
communication
0-55 FCU does not detect the
SG3.
0-56
The stored message data
exceeds the capacity of the
mailbox in the SG3.
0-70 The communication mode
specified in CM/JM was not
available
(V.8 calling and called
terminal)
0-74 The calling terminal fell back
to T.30 mode, because it
could not detect ANSam
after sending CI.
0-75 The called terminal fell back
to T.30 mode, because it
could not detect a CM in
response to ANSam
(ANSam timeout).
0-76 The calling terminal fell back
to T.30 mode, because it
could not detect a JM in
response to CM
(CM timeout).
0-77 The called terminal fell back
to T.30 mode, because it
could not detect a CJ in
response to JM
(JM timeout).
0-79 The called terminal detected
CI while waiting for a V.21
signal.
B819/B820
CÓPIA NÃO CONTROLADA
Check the protocol dump list.
Ask the other party to contact the manufacturer.
Check the line connection.
The other terminal may have a defective
modem/FCU.
Check the line connection.
Retry communication.
FCU firmware or board defective.
SG3 firmware or board defective.
SG3 firmware or board defective.
The other terminal did not have a compatible
communication mode (e.g., the other terminal was a
V.34 data modem and not a fax modem.)
A polling Tx file was not ready at the other terminal
when polling Rx was initiated from the calling
terminal.
The calling terminal could not detect ANSam due to
noise, etc.
ANSam was too short to detect.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
The terminal could not detect ANSam.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
The called terminal could not detect a CM due to
noise, etc.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
The calling terminal could not detect a JM due to
noise, etc.
A network that has narrow bandwidth cannot pass JM
to the other end.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
Check for line noise or other line problems.
If this error occurs, the called terminal falls back to
T.30 mode.
26
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
SM