Ricoh B064 SERIES Service Manual page 1402

BIT SWITCHES
G3 Switch 0E [SP No 1-105-015]
Set CNG send time interval
Some machines on the receiving side may not be able to automatically switch the
3-second CNG interval.
0-7
High order bit
Low order bit
G3 Switch 0F [SP No. 1-105-016]
No
Alarm when an error occurred
in Phase C or later
0
0: Disabled
1: Enabled
Alarm when the handset is off-
hook at the end of
1 communication
0: Disabled
1: Enabled
2 Not used
⇒
SIDAA manual calibration
setting
4
0: Off
1: On
5-7 Not used
B819/B820
CÓPIA NÃO CONTROLADA
FUNCTION
CÓPIA NÃO CONTROLADA
3000-2250ms: 3000-50xNms
3000 – 50 x Nms 0F (3000 ms) ≤ N ≤ FF (2250
ms)
00-0E(3000-3700ms: 3000+50xNms
3000 – 50 x Nms 0F (3000 ms) ≤ N ≤ 0F (3700
ms)
COMMENTS
If the customer wants to hear an alarm after each
error communication, change this bit to "1".
If the customer wants to hear an alarm if the
handset is off-hook at the end of fax
communication, change this bit to "1".
Do not change the settings.
1: Manually calibrates for communication with a
line, whose current change occurs such as an
optical fiber line.
NOTE: SIDAA means Silicon Direct Access
Arrangement. In this case, it refers to the
changing of the telecommunications line I/F, i.e.
FAX communication circuit, from software to
hardware (IC-based) control. Its settings can be
changed if trouble with FAX transmission or
reception occurs.
Do not change the settings.
92
Rev. 07/2007
SM