Ricoh B064 SERIES Service Manual page 1368

BIT SWITCHES
System Switch 0E [SP No. 1-101-015]
No FUNCTION
0-1 Not used
Enable/disable for direct
sending selection
2
0: Direct sending off
1: Direct sending on
Action when the external
handset goes off-hook
0: Manual tx and rx operation
3
1: Memory tx and rx operation
(the display remains the
same)
4-7 Not used
System Switch 0F [SP No. 1-101-016]
No FUNCTION
Country/area code for functional
0-7
settings (Hex)
00: France
01: Germany
02: UK
03: Italy
04: Austria
05: Belgium
06: Denmark
07: Finland
08: Ireland
09: Norway
0A: Sweden
0B: Switzerland
0C: Portugal
B819/B820
CÓPIA NÃO CONTROLADA
Do not change the settings.
Direct sending cannot operate when the capture
function is on during sending. Setting this switch
to "1" enables direct sending without capture.
Setting this switch to "0" masks the direct sending
function on the operation panel so it cannot be
selected.
0: Manual Tx and Rx are possible while the
external handset is off-hook. However, memory Tx
is not possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory Tx operation.
Note that manual Tx and Rx are not possible with
this setting.
Do not change these settings.
COMMENTS
This country/area code determines the
factory settings of bit switches and RAM
addresses. However, it has no effect on the
11: USA
NCU parameter settings and communication
parameter RAM addresses.
12: Asia
Cross reference
NCU country code:
12: Asia
SP No. 2-103-001 for G3-1
13: Japan SP No. 2-104-001 for G3-2
SP No. 2-105-001 for G3-3
14: Hong Kong
15: South Africa
16: Australia
17: New Zealand
18: Singapore
19: Malaysia
1A: China
1B: Formosa
1C: Korea
CÓPIA NÃO CONTROLADA
COMMENTS
58 SM