Ricoh B064 SERIES Service Manual page 1334

ERROR CODES
Code Meaning
0-07 No post-message response
from the other end after a
page was sent
0-08 The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
0-14 Non-standard post message
response code received
0-15
The other terminal is not
capable of specific functions.
0-16
CFR or FTT not detected
after modem training in
confidential or transfer mode
B819/B820
CÓPIA NÃO CONTROLADA
Check the line connection.
Replace the FCU.
The other end may have jammed or run out of paper.
The other end user may have disconnected the call.
Check for a bad line.
The other end may be defective; try sending to
another machine.
Check the line connection.
Replace the FCU.
The other end may have jammed, or run out of paper
or memory space.
Try adjusting the Tx level and/or cable equalizer
settings.
The other end may have a defective modem/FCU; try
sending to another machine.
Check for line problems and noise.
Cross reference
Tx level - NCU Parameter 01 (PSTN)
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program Mode
Incompatible or defective remote terminal; try sending
to another machine.
Noisy line: resend.
Try adjusting the Tx level and/or cable equalizer
settings.
Replace the FCU.
Cross reference
See error code 0-08.
The other terminal is not capable of accepting the
following functions, or the other terminal's memory is
full.
Confidential Rx
Transfer function
SEP/SUB/PWD/SID
Check the line connection.
Replace the FCU.
Try adjusting the Tx level and/or cable equalizer
settings.
The other end may have disconnected, or it may be
defective; try calling another machine.
If the Rx signal level is too low, there may be a line
problem.
Cross reference
See error code 0-08.
24
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
SM