Ricoh B064 SERIES Service Manual page 1390

BIT SWITCHES
Communication Switch 09 [SP No. 1-104-010]
No FUNCTION
0-7 IP-Fax dial interval setting
Communication Switch 0A [SP No. 1-104-011]
No FUNCTION
Point of resumption of
memory transmission upon
0 redialing
0: From the error page
1: From page 1
1-7 Not used
Communication Switch 0B - Not used (do not change the settings)
Communication Switch 0C - Not used (do not change the settings)
Communication Switch 0D [SP No. 1-104-014]
No FUNCTION
The available memory
threshold, below which ringing
0-7
detection (and therefore
reception into memory) is
disabled
B819/B820
CÓPIA NÃO CONTROLADA
Adjusts the interval of the I-fax dialing.
The interval of I-fax dialing is calculated by
following formula.
[Interval time = specified value with this switch x
0.2 msec]
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page, using
normal memory transmission.
Do not change the settings.
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
80
CÓPIA NÃO CONTROLADA
COMMENTS
COMMENTS
COMMENTS
SM