Fold Adjustments (B700 Only); Folding Horizontal Skew Adjustment - Ricoh B064 SERIES Service Manual

1.11 FOLD ADJUSTMENTS (B700 ONLY)

1.11.1 FOLDING HORIZONTAL SKEW ADJUSTMENT

[D]
[C]
[E]
Important
• The fold unit is adjusted for optimum performance before the finisher is shipped
from the factory. Do this adjustment only if the edges of folded booklets are not
even.
1. Switch the copier on and enter the SP mode.
2. Europe, Asia: Use SP 6113 001 (this is for A3 paper).
North America: Use SP 6113 005 (this is for DLT paper).
NOTE: If the original setting of SP6113 001 or 005 is not 0, then you must do
the vertical skew adjustment ( 1.11.2) after you finish this horizontal
skew procedure.
3. Use the 10-key pad to input "-2" (mm) for the SP value.
NOTE: (Press [٠/ ] to enter the minus sign.)
4. Press [#] then exit the SP mode.
5. Open the front door and pull the stapler unit [A] out of the finisher.
6. Open the guide plate [B].
7. Loosen the adjustment screw [C] and then tighten until it stops. (Do not over
tighten.)
8. Remove the lock screw [D].
9. Raise the tip [E] of the adjustment screw very slightly and allow it to descend
under its own weight.
SM
CÓPIA NÃO CONTROLADA
13
CÓPIA NÃO CONTROLADA
FOLD ADJUSTMENTS (B700 ONLY)
[A]
[B]
B700R802.WMF
B700/B701