Ncu Parameters - Ricoh B064 SERIES Service Manual

Hide thumbs Also See for B064 SERIES:

Table of Contents

NCU PARAMETERS

The following tables give the RAM addresses and the parameter calculation units

that the machine uses for ringing signal detection and automatic dialing. The

factory settings for each country are also given. Most of these must be changed by

RAM read/write (SP2-102), but some can be changed using NCU Parameter

programming (SP2-103, 104 and 105); if SP2-103, 104 and 105 can be used, this

will be indicated in the Remarks column. The RAM is programmed in hex code

unless (BCD) is included in the Unit column.

NOTE: 1) The following addresses describe settings for the standard NCU.

2) Change the fourth digit from "5" to "6" (e.g. 680500 to 680600) for the

settings for the first optional G3 interface unit and from "5" to "7" (e.g.

680700) for the settings for the second optional G3 interface unit.

Country/Area code for NCU parameters

Use the Hex value to program the country/area code directly into this

address, or use the decimal value to program it using SP2-103-001

CÓPIA NÃO CONTROLADA

CÓPIA NÃO CONTROLADA

NCU PARAMETERS

South Africa

Table of Contents

B246 series B140 series D052 series