Ricoh B064 SERIES Service Manual page 1279

Hide thumbs Also See for B064 SERIES:

Table of Contents

At the beginning of the job, the jogger fence motor (M15) [A] switches on and

moves the jogger fences [B] to the standby position (7.5 mm from the sides of the

selected paper size).

When each sheet passes the pre-stack tray exit sensor (S2) and enters the

stapling tray:

• The jogger fence motor switches on and moves the jogger fences to within 5.5

mm of the sides of the selected paper size.

• The positioning roller solenoid (SOL3) switches on for the time prescribed for the

paper size. This pushes the positioning roller [C] onto the sheet and pushes it

down onto bottom fence. This aligns the edge of the stack.

Next, the jogger fence motor:

• Switches on again and moves the jogger fences to within 2.6 mm of the sides of

the stack to align the sides of the stack.

• Reverses and moves the fences to the standby position (7.5 mm away for the

sides) and waits for the next sheet.

• The jogger fence HP sensor [D] switches off the jogger motor at the end of the

After the last sheet feeds:

• The stapling edge pressure plate solenoid [E] (SOL4) switches on and pushes

the pressure plate [F] onto the stack to press down the edge for stapling.

• The corner stapler staples the stack.

CÓPIA NÃO CONTROLADA

CORNER STAPLING

Chapters

Table of Contents

B246 series B140 series D052 series