Ricoh B064 SERIES Service Manual page 1249

[D]
15. Open the front door of the finisher and pull the stapler unit [A] out.
16. Open the guide plate [B].
17. Turn the adjustment screw [C] to correct the amount of skew you measured
from the test sheet.
• For + skew ([A] on the previous page), turn the adjustment screw
(clockwise).
• For – skew ([B] on the previous page), turn the adjustment screw to the
left (counter-clockwise).
• Every click in the +/– direction adjusts the fold position by 0.1 mm by moving
the bottom fence [D]
18. Raise the tip of the adjustment screw [C] and allow it to lower under its own
weight.
19. Attach and tighten the lock screw [E].
20. Push the stapler unit into the machine, close the front door, then turn the copier
on.
21. Europe, Asia: Do SP 6113 001 (this is for A3 paper).
North America: Do SP 6113 005 (this is for DLT paper).
22. Reset it to "0".
23. Do the test again.
24. If the result is satisfactory, this completes the adjustment.
-or-
If some skew remains, repeat this adjustment.
NOTE: After doing this adjustment, adjust for vertical skew, if necessary.
( 1.11.2).
SM
CÓPIA NÃO CONTROLADA
[E]
[C]
[B]
15
CÓPIA NÃO CONTROLADA
FOLD ADJUSTMENTS (B700 ONLY)
B700R130A.WMF
[A]
B700/B701