Ricoh B064 SERIES Service Manual page 1339

Code Meaning
5-25 SAF file access error
6-00
G3 ECM - T1 time out during
reception of facsimile data
6-01 G3 ECM - no V.21 signal
was received
6-02
G3 ECM - EOR was
received
6-04 G3 ECM - RTC not detected
6-05 G3 ECM - facsimile data
frame not received within 18
s of CFR, but there was no
line fail
6-06 G3 ECM - coding/decoding
error
6-08 G3 ECM - PIP/PIN received
in reply to PPS.NULL
6-09 G3 ECM - ERR received
6-10 G3 ECM - error frames still
received at the other end
after all communication
attempts at 2400 bps
6-21 V.21 flag detected during
high speed modem
communication
6-22 The machine resets the
sequence because of an
abnormal handshake in the
V.34 control channel
6-99 V.21 signal not stopped
within 6 s
13-17 SIP user name registration
error
SM
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
Replace an SD card or HDD.
Replace the FCU.
Try adjusting the rx cable equalizer.
Replace the FCU.
Check the line connection.
Check for a bad line or defective remote terminal.
Replace the FCU.
Check the line connection.
Check for a bad line or defective remote terminal.
Replace the FCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the Tx levels of the communicating machines.
See code 6-05.
Check for line noise.
Adjust the Tx level (use NCU parameter 01 or the
dedicated Tx parameter for that address).
Check the line connection.
Defective remote terminal.
The other terminal may be defective or incompatible.
Check for line noise.
If the same error occurs frequently, replace the FCU.
Defective remote terminal.
Replace the FCU.
Double registration of the SIP user name.
Capacity for user-name registration in the SIP server
is not sufficient.
29
CÓPIA NÃO CONTROLADA
ERROR CODES
B819/B820