Ricoh B064 SERIES Service Manual page 1338

ERROR CODES
Code Meaning
2-23 JBIG compression or
reconstruction error
2-24 JBIG ASIC error
2-25 JBIG data reconstruction
error (BIH error)
2-26 JBIG data reconstruction
error (Float marker error)
2-27 JBIG data reconstruction
error (End marker error)
2-28 JBIG data reconstruction
error (Timeout)
2-29 JBIG trailing edge maker
error
2-50 The machine resets itself for
a fatal FCU system error
2-51 The machine resets itself
because of a fatal
communication error
2-53 Snd msg() in the manual
task is an error because the
mailbox for the operation
task is full.
4-01 Line current was cut
4-10 Communication failed
because of an ID Code
mismatch (Closed Network)
or Tel. No./CSI mismatch
(Protection against Wrong
Connections)
5-10 DCR timer expired
5-20
Storage impossible because
of a lack of memory
5-21 Memory overflow
5-23
Print data error when
printing a substitute rx or
confidential rx message
B819/B820
CÓPIA NÃO CONTROLADA
Turn off the machine, then turn it back on.
Turn off the machine, then turn it back on.
JBIG data error
Check the sender's JBIG function.
Update the MBU ROM.
FCU defective
Check the destination device.
If this is frequent, update the ROM, or replace the
FCU.
If this is frequent, update the ROM, or replace the
FCU.
The user did the same operation many times, and this
gave too much load to the machine.
Check the line connector.
Check for line problems.
Replace the FCU.
Get the ID Codes the same and/or the CSIs
programmed correctly, then resend.
The machine at the other end may be defective.
Replace the FCU.
Temporary memory shortage.
Test the SAF memory.
Test the SAF memory.
Ask the other end to resend the message.
28
CÓPIA NÃO CONTROLADA
Suggested Cause/Action
SM