Installation Procedure - Ricoh B064 SERIES Service Manual

G3 INTERFACE UNIT TYPE 7500 (B820)

1.2.2 INSTALLATION PROCEDURE

G3 Board Installation
CAUTION
Before installing this optional unit,
1) Print out all data in the printer buffer.
2) Turn off the main switch and disconnect the power cord and the
network cable.
1. Disconnect the ADF connector [A].
2. Remove the rear upper cover [B] (
• Slide down to remove.
• When re-attaching, before tightening the screws make sure that the tabs on
the cover are engaged with the shoulder screws.
3. Remove the rear lower cover [C] (
• When re-attaching, before tightening the screws make sure that the tabs on
the cover are engaged with the shoulder screws.
B819/B820
CÓPIA NÃO CONTROLADA
x 2)
x 2)
16
CÓPIA NÃO CONTROLADA
[A]
[B]
[C]
B820R102.WMF
SM