Chapter 4 Basic Configuration; Presettings; Preconfigured Data - Funkwerk W1002 Manual

Funkwerk Enterprise Communications GmbH
bintec W1002/W1002n/W2002/WIx040/WIx065

Chapter 4 Basic configuration

You can use the ComPoint Manager (IP address assignment) and the Funkwerk Config-
uration Interface (other configuration steps) for the basic configuration of your device.
The basic configuration is explained below step-by-step. A detailed online help system
gives you extra support.
This user's guide assumes you have the following basic knowledge:
• Basic knowledge of network structure
• Knowledge of basic network terminology, such as server, client and IP address
• Basic knowledge of using Microsoft Windows operating systems
The CD also supplied includes all the tools that you need for the configuration and man-
agement of your device.
You can find other useful applications on the Internet at

4.1 Presettings

4.1.1 Preconfigured data

You have three ways of accessing your device in your network to perform configuration
tasks:
(a) Dynamic IP address
In ex works state, your device is set to DHCP client mode, which means that when it is
connected to the network, it is automatically assigned an IP address if a DHCP server
is run. You can then access your device for configuration purposes using the IP ad-
dress assigned by the DHCP server. For information on determining the dynamically
assigned IP address, please see your DHCP server documentation.
(b) Fallback IP address
If you do not run a DHCP server, you can connect your device directly to your configur-
ation PC and then reach it using the following, predefined fallback IP configuration:
• IP Address: 192.168.0.252
• Netmask: 255.255.255.0
Make sure that the PC from which the configuration is performed has a suitable IP
4 Basic configuration
www.funkwerk-ec.com .
13