Nat Interfaces - Funkwerk W1002 Manual

12 Routing
184

12.2.1 NAT Interfaces

Network Address Translation (NAT) is a function on your device for defined conversion of
source and destination addresses of IP packets. If NAT is activated, IP connections are still
only allowed by default in one direction, outgoing (forward) (= protective function). Excep-
tions to the rule can be configured (in
In the Routing -> NAT -> NAT Interfaces menu, a list of all NAT interfaces is shown.
Routing NAT
Fig. 82: -> ->
For each NAT interface, you can select the options NAT Active, Silent Deny and
PPTP Passthrough.
In addition, Portforwardings displays how many portforwarding rules were configured
for this interface.
Options in the menu NAT Interfaces
Field
NAT Active
Silent Deny
Funkwerk Enterprise Communications GmbH
Portforwarding
NAT Interfaces
Description
Select whether NAT is to be activated for the interface.
The function is disabled by default.
Select whether IP packets are to be silently denied by NAT. If
this function is deactivated, the sender of the denied IP packet
is informed by means of an ICMP or TCP RST message.
bintec W1002/W1002n/W2002/WIx040/WIx065
on page 185).