The Basic Configuration; Booting The Compoint Manager - Funkwerk W1002 Manual

The Basic Configuration

The Basic Configuration

Booting the ComPoint Manager

Prerequisite:
To make the required settings, you have to assign an IP address to
the funkwerk Wx002 via the ComPoint Manager (see Section
Basic Configuration
start the configuration via a terminal program (e.g. Telnet) or a
browser.
This chapter describes which steps have to be performed in order
to assign an IP address to your funkwerk Wx002 via the ComPoint
Manager.
To configure an IP address for your funkwerk Wx002, carry out
the following steps:
Prerequisite:
The PC which you use to configure the IP address for your
funkwerk Wx002 has to be connected to the same network as the
funkwerk Wx002 to be configured.
1. Insert the supplied CD into the drive of the corresponding
computer.
2. Carry out the instructions of the CD wizard and install the
ComPoint Manager.
3. Start the ComPoint Manager from the Start > Programs >
funkwerk > ComPoint Manager menu.
The following dialog box is displayed:
on page Page B1–7). Afterwards, you can
The
1-7