Options - Funkwerk W1002 Manual

8 System management
116
Field
Blocktime
Encryption

8.5.3 Options

This setting possible here causes your device to carry out authentication negotiation for in-
coming calls, if it cannot identify the calling party number (e.g. because the remote terminal
does not signal the calling party number). If the data (password, partner PPP ID) obtained
by executing the authentication protocol is the same as the data of a listed remote terminal
or RADIUS user, your device accepts the incoming call.
Funkwerk Enterprise Communications GmbH
Description
If a response is not received during the wait time, the next con-
figured TACACS+ server is queried (only if Policy = Non-
authoritative) and the current server is set to status
Blocked.
The possible values are 1 to 60, the default value is 3.
Enter the time in seconds for which the current server is to re-
main in blocked status.
At the end of the block time, the server is set to the status spe-
cified in the Administrative Status field.
The possible values are 0 to 3600, the default value is 60. The
value 0 means that the server is never set to Blocked status
and thus no other servers are queried.
Select whether data exchange between the TACACS+ server
and the NAS is to be encrypted with MD5.
The function is activated by choosing Enabled.
The function is enabled by default.
If the function is not enabled, the packets and all related inform-
ation are transferred unencrypted. Unencrypted transfer is not
recommended as a default setting and should only be used for
debugging.
bintec W1002/W1002n/W2002/WIx040/WIx065