Connections - Funkwerk W1002 Manual

6 Technical data
42
LED
(2x green)
SFP (green)
During the boot operation, only the red LED is on. The other LEDs then come on during
booting (if the units are initialised).

6.2.4 Connections

All connections are located on the underside of the device. bintec WI1040, WI2040 und
WI3040 have two Ethernet connections and one Serial interface.
The connections are arranged as follows:
bintec WI1040
Fig. 20: Underside of
bintec WIx040 underside
1 Power
2 Eth1 (PoE) / Eth2
3 Reset (HW and
Cfg)
4 SFP
5 Serial
6 MMC/SD card
7 Relay N/O
Funkwerk Enterprise Communications GmbH
State
on
on (flickering)
off
on
on (flickering)
WI2040 WI3040
, and
Socket for power supply
10/100 Base-T Ethernet interface
Reset button and delete configuration
SFP slot for 100 mbps fibre module (optional)
Serial interface RS232
Multimedia card (optional)
Alarm relay
bintec W1002/W1002n/W2002/WIx040/WIx065
Information
Cable plugged in and link
Cable plugged in and link with data
traffic
No data traffic
Data traffic via the SFP interface.
Cable plugged in and data traffic