Leds - Funkwerk W1002 Manual

Funkwerk Enterprise Communications GmbH
bintec W1002/W1002n/W2002/WIx040/WIx065

6.2.3 LEDs

By means of the eight LEDs, you can see the wireless status, wireless activity, Ethernet
activity and LED states of your device. The LED states are indicated by combinations of the
LEDs which are explained in detail in this chapter.
They are arranged as follows:
bintec WI1040
Fig. 19: LEDs of
In operation mode, the LEDs display the following status information for your device:
LED status display
LED
Failure (red)
Status (green)
WLAN 1/2/3 (3x green)
ETH 1/2
WI2040 WI3040
, and
State
on
off
off
on (static)
on (flashing)
on (flashing slowly)
on (static)
on (flickering)
on (flashing fast)
on (flashing fast)
off
Information
After power-up and during booting or
if an error occurs.
If the device is at the login prompt.
The power supply is not connected. If
other LEDs are on, also Error.
Error
Ready
Free
At least one client is registered
At least one client is registered and
there is data traffic
BLD (Broken Link Detection) active
5 GHz scan active
No cable or no Ethernet link
6 Technical data
41